Canon PG 40 Refill Instructions

Instructions

1. Put the cartridge on some paper towels in an area where you can tolerate a spill.
2. Drill a hole into the dimple just below the "B".
3. Fill the syringe with 20 ml. of black ink.
4. Very slowly & carefully inject ink into any hole.
5. When finished, put a small piece of tape over the drilled hole.
6. Replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions.
For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge. Note: Each time the cartridge is removed from the printer an "empty cartridge" message appears and a blinking amber light will come on, on the printer. Holding the paper feed button down for 3-5 sec. will allow you to override the counter.

PG 41 Refill Instructions

Instructions
1. Put the cartridge on some paper towels in an area where you can tolerate a spill.
2. Peal off the top label.
3. You will notice three small holes (too small for a syringe needle to get into). Drill each hole larger with a thumb drill.
4. Fill the syringe with 6 ml. of colour ink ( Cyan, Yellow & Magenta).
5. Very SLOWLY & CAREFULLY inject ink into each chamber until the sponge full
6. When finished, replace the top label or cover with tape.
7. Replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions.